Examples of installation & Application  

Home > Products > Operation > Electromagnetic Particle Clutch and Brake > Examples of installation & Application

Basic Design and Operation Basic Construction 
Examples of installation & Application

ZKC Examples of installation
Insert tray assembly into the installation board to hold it in place.
   
The spring coupler must be used to main contact between the clutch shaft and the load shaft. In addition, the alignment and angles between shafts mush be maintained with the allowable range for spring coupler.
   
Stay within permitted load ranges when installing a belt pan.
   
Installation plates must be installed at either end of the shaft for the ZKC005AA.
 

 
ZKB Examples of installation
Insert tray assembly into the installation board to hold it in place.
   
The spring coupler must be used to main contact between the clutch shaft and the lad shaft. In addition, the alignment and angles between shafts mush be maintained with the allowable range for spring coupler.
   
Stay within permitted load ranges when installing a belt pan.
 

 
ZKY Examples of installation
Installation environment
Installation flange must be firmly attached to the installation board.
   
Driving and driven shaft must be connected by a flexible clutched factors such as shaft concentricity, right angles, etc., must be within the specified limits of the clutch.
   
When installing a belt pan, stay within permitted load ranges.
   
Minimum surface area for an installed heat dissipation panel is 350cm2
 

 
ZKA Examples of installation
Installation flange must be firmly attached to the installation board.
   
Drive shaft and load shaft must be connected by a spring coupler, and the alignment and angles must be correct.
   
When installing a belt pan, stay within permitted load ranges.
   
Minimum surface area for an installed heat dissipation panel is 350cm2
   
 
   
ZKX Examples of installation
The front of bearing must be firmly attached to the installation board.
   
Drive shaft and load shaft must be connected by a spring coupler, and the alignment and angles between shafts must be maintained with the allowable range for spring coupler.
   
If the load shaft is hold by the internal bearing inside the brake, please prevent it from being hold by only 3 points. (there are 2 internal bearing inside the brake)